Może się komuś przydać
Goście nie mogą oglądać obrazków w postach. Zarejestruj się klikając tutaj aby uzyskać pełen dostęp do forum.
Goście nie mogą oglądać obrazków w postach. Zarejestruj się klikając tutaj aby uzyskać pełen dostęp do forum.
Goście nie mogą oglądać obrazków w postach. Zarejestruj się klikając tutaj aby uzyskać pełen dostęp do forum.
Goście nie mogą oglądać obrazków w postach. Zarejestruj się klikając tutaj aby uzyskać pełen dostęp do forum.
Goście nie mogą oglądać obrazków w postach. Zarejestruj się klikając tutaj aby uzyskać pełen dostęp do forum.
Goście nie mogą oglądać obrazków w postach. Zarejestruj się klikając tutaj aby uzyskać pełen dostęp do forum.
Goście nie mogą oglądać obrazków w postach. Zarejestruj się klikając tutaj aby uzyskać pełen dostęp do forum.
Use the wiring Diagram as a guide .
you need to first cut 6 wires about 3 amp will do approx 6 inches long , different colours would be better , if not then mark them individually (14 , 11 , 6 , 3 , Hcan , and Lcan.
connections are numbered.
Cut protective shrink wrap off 14 and DE-Solder the wire.
Shrink wrap all wires
Solder Number 14 wire to number 14 on the connector side
Solder Number 11 wire to spare number 11 on the connector side
Solder Number Lcan wire to the original number 14 wire you DE-Soldered.
Cut protective shrink wrap off number 6 and DE-Solder the wire.
Solder Number 6 wire to number 6 on the connector side
Solder Number 3 wire to spare number 3 on connector side
Solder Number Hcan wire to the original number 6 wire you DE-Soldered.
Cut a small section of the box out to allow room for the cables to leave the box.
Plug the connector back into the board and route wires and place lid back on the ELM
Screw casing back together.
Tape together for can-H setup as follows.
Number 3 wire to can-H wire
Number 11 wire to can-L wire
tape up number 6 wire
tape up number 14 wire
Of course with a switch in place you can easily switch between to two configs.