View Single Post
Stary 02-10-2013, 19:19   #1
Addo
ford::amateur
 
Zarejestrowany: 10-09-2013
Model: S-max
Silnik: 2.0 tdci
Rocznik: 2007
Postów: 1
Domyślnie Błąd DTC U3000:00-68 Webasto co z tym ?

Mam extra marka postojowe Webasto moim problemem jest to, że pojawia się kod DTC kod błędu U3000:00-49, gdy usunę kod działa grzejnik jak należy aż do następnego dnia, gdy kod błędu pojawia się ponownie.

kiedy czytałem kody błędów mówi, że będę Controller sprawdzić moduł abs. co ma ABS z dodatkową grzałkę do zrobienia? Jestem bardzo wdzięczny za wszelką pomoc można uzyskać



===DTC U3000:00-68===
Code: U3000 - Control Module

Subcode: 49 - Internal Electronic Failure

Status: 68

Module: Auxiliary Heater Control Module

Diagnostic Trouble Code details

Perform these checks

Check the %%h(ABS)(EB9F) module ground connections.

Check the %%h(ABS)(EB9F) module power supply connections.

Check the condition of all cables and connectors for broken cables, damaged insulation, contamination, water ingress and loose connections.

Check the %%h(ABS)(EB9F) module connections for damage, water ingress or corrosion . If any contamination is found, clean the connector and %%h(ABS)(EB9F) module terminals.

Check the connector for damage or contamination.

Check for an open circuit in the wiring harness.

Check for a short circuit to the ground or battery.

Check the condition of all cables and connectors for broken cables, damaged insulation, contamination and loose connections. Make sure there is no continuity to ground or supply.

Select Self-Test in the toolbox menu, select Chassis -> Braking -> %%h(ABS)(EB9F) or %%h(ESP)(1871Goście nie mogą oglądać obrazków w postach. Zarejestruj się klikając tutaj aby uzyskać pełen dostęp do forum., depending on the system. Perform an On Demand Self-Test.

If the %%h(DTC)(FA1Goście nie mogą oglądać obrazków w postach. Zarejestruj się klikając tutaj aby uzyskać pełen dostęp do forum. is ODDTC and not historical or continuous, do not delete the DTC and replace the %%h(ABS)(EB9F) module.

If the %%h(DTC)(FA1Goście nie mogą oglądać obrazków w postach. Zarejestruj się klikając tutaj aby uzyskać pełen dostęp do forum. is %%h(CMDTCs)(186CA) and historically this may be an intermittent fault, the cause of which cannot be identified at this time. The customer should return the car should the fault reoccur noting the conditions at the time of the failure like the speed and application of the brakes.

===END DTC U3000:00-68===

Ostatnio edytowane przez Addo ; 03-10-2013 o 08:24
Addo jest offline   Odpowiedź z Cytatem