Od niedawna (pare mies) od czasu do czasu pojawi mi sie Engine Check z komunikatem “proximity system malfunction” (radar zblizeniowy). Oczywiscie przestaja dzialac hill assist, tempomat etc. Moc silnika jest ograniczana.
Dzieje sie to z rozna czestotliwoscia. 2 mies temu mialem tak codziennie przez weekend. potem tydzien przerwy. Przed dzisiejsza sytuacja minelo ponad miesiac. Zwykle w drodze, wiec nie mam mozliwosci odwiezdc z tym bledem do serwisu.
Po skasowaniu bledu forscanem (czasami trzeba 2x bo za pierwszym zostaje blad abs) jade dalej.
ponizej wypis z dzisiaj. Spotkal sie ktos z kombinacja tych bledow? mozna zgadnac z duzym prawdopodobienstwem czy to pedal gazu czy cos innego?
Kod:
===PCM DTC P2125:00-28===
Code: P2125 - Throttle/Pedal Position Sensor/Switch E Circuit
Status:
- Previously Set DTC - Not Present at Time of Request
- Malfunction Indicator Lamp is Off for this DTC
Module: Powertrain Control Module
Freeze Frame :
-GLOBTIM: 333907399 s - Global real time
-TOTDIST: 263234.0 km - Total Distance
-MAINECUV: 11.75 V - Main ECU voltage supply
-ESTSERUN: No - Engine status - engine running
-ESTSECRK: No - Engine status - engine in crank
-INCARTMP: 21 °C - In car temperature
-OUTTMP: 22 °C - External Temperature From Sensor
===END PCM DTC===
===PCM DTC P2138:00-2F===
Code: P2138 - Throttle/Pedal Position Sensor/Switch D/E Voltage Correlation
Status:
- DTC Present at Time of Request
- Malfunction Indicator Lamp is Off for this DTC
Module: Powertrain Control Module
Freeze Frame :
-GLOBTIM: 333894564 s - Global real time
-TOTDIST: 263234.0 km - Total Distance
-MAINECUV: 12.75 V - Main ECU voltage supply
-ESTSERUN: No - Engine status - engine running
-ESTSECRK: No - Engine status - engine in crank
-INCARTMP: 18 °C - In car temperature
-OUTTMP: 17 °C - External Temperature From Sensor
===END PCM DTC===
===OBDII DTC ===
Successful DTC reading, no error codes found
Module: On Board Diagnostic II
===END OBDII DTC===
===SASM DTC ===
Successful DTC reading, no error codes found
Module: Steering Angle Sensor Module
===END SASM DTC===
===CCMii DTC U0401:86-AF===
Code: U0401 - Invalid Data Received from ECM/PCM A
Additional Fault Symptom:
- Signal Invalid
Status:
- DTC Present at Time of Request
- Malfunction Indicator Lamp is On for this DTC
Module: Cruise Control Module
===END CCMii DTC===
===CCMii DTC U0415:86-AF===
Code: U0415 - Invalid Data Received from Anti-Lock Brake System (ABS) Control Module A
Additional Fault Symptom:
- Signal Invalid
Status:
- DTC Present at Time of Request
- Malfunction Indicator Lamp is On for this DTC
Module: Cruise Control Module
===END CCMii DTC===
===ABS DTC U0401:68-8A===
Code: U0401 - Invalid Data Received from ECM/PCM A
Additional Fault Symptom:
- Event Information
Status:
- DTC Present at Time of Request
- Malfunction Indicator Lamp is On for this DTC
Module: Antilock braking system
===END ABS DTC===
===RCM DTC ===
Successful DTC reading, no error codes found
Module: Restraint Control Module
===END RCM DTC===
===HCM DTC ===
Successful DTC reading, no error codes found
Module: Headlamp Control Module
===END HCM DTC===
===BCMii DTC B1029:21-28===
Code: B1029 - Accelerator Pedal Sensor
Additional Fault Symptom:
- Signal Amplitude Less Than Minimum
Status:
- Previously Set DTC - Not Present at Time of Request
- Malfunction Indicator Lamp is Off for this DTC
Module: Body Control Module
Freeze Frame :
-GLOBTIM: 333907400 s - Global real time
-TOTDIST: 263234.0 km - Total Distance
-MAINECUV: 11.75 V - Main ECU voltage supply
-INCARTMP: 21 °C - In car temperature
===END BCMii DTC===