Odp: Wymiana BCM
BCM wymieniony i działa dzięki Łukaszowi Kołodziej z pod Krakowa, wielkie dzięki, straciłem juz nadzieje. PAM pozwala zaprogramować bez błędu 10 czujników PDC /przedlift/ mam tylko jeden problem to znaczy wysypał się TPMS jest 7 błędów i komunikat na zegarach. Nie wiem czy zaprogramowanie ponowne czujników wystarczy? Moze ktos coś zasugeruje? To lista błędów z BCM
DTC Error read - BCM
DTC Errors: 7
B1182 - Tire Pressure Monitoring System
B1182 - Consumer Device Authentification Failed
Status: 55 - Not Configured
Ext.Status: 8A - Minimum Adaption Limit Not Reached.(DTC) Maturing - Intermittent at Time of Request.
C1A56 - Front Left Wheel Module
Status: 51 - Not Programmed
Ext.Status: 48 - Cylinder 5.(DTC) Present at Time of Request.
C1A58 - Front Right Wheel Module
Status: 51 - Not Programmed
Ext.Status: 48 - Cylinder 5.(DTC) Present at Time of Request.
B1254 - Right Rear (Outside on Dual Wheel) Tire Pressure Sensor and Transmitter Assembly
B1254 - Climate Control Air Temperature External Sensor Circuit Failure
Status: 51 - Not Programmed
Ext.Status: 48 - Cylinder 5.(DTC) Present at Time of Request.
B1255 - Left Rear (Outside On Dual Wheel) Tire Pressure Sensor and Transmitter Assembly
B1255 - External air temperature sensor circuit open
Status: 51 - Not Programmed
Ext.Status: 48 - Cylinder 5.(DTC) Present at Time of Request.
B124D - Tire Pressure Sensor
Status: 02 - General Signal Failure
Ext.Status: 8A - Minimum Adaption Limit Not Reached.(DTC) Maturing - Intermittent at Time of Request.
B1182 - Tire Pressure Monitoring System
B1182 - Consumer Device Authentification Failed
Ext.Status: 8A - Minimum Adaption Limit Not Reached.(DTC) Maturing - Intermittent at Time of Request.
00- Error status not found in base....
|