View Single Post
Stary 31-03-2025, 12:48   #3
domadm
ford::advanced
 
Avatar domadm
 
Zarejestrowany: 26-12-2009
Skąd: ze Śląska
Model: Ranger Wildtrak P703
Silnik: 2.0 205KM
Rocznik: 2024
Postów: 305
Domyślnie Odp: Dezaktywacja czujnika zapiętych pasów

Znalazłem na anglojęzycznym forum procedurę dezaktywacji sygnalizacji dźwiękowej niezapiętych pasów Goście nie mogą oglądać obrazków w postach. Zarejestruj się klikając tutaj aby uzyskać pełen dostęp do forum.
W polskim podręczniku jest tylko wzmianka, żeby skontaktować się z autoryzowanym dealerem, a w anglojęzycznym jest opisana procedura:

How to turn-off the seatbelt warning sound:
(from the Manual, page 57)

Read Steps 1 - 4 before proceeding with
the programming procedure.
Make sure that:
• You set the parking brake.
• The transmission is in park (P).
• The ignition is off.
• You close all vehicle doors.
• You unfasten the driver and front
passenger seatbelts.

1. Switch the ignition on. Do not start the
engine.
2. After Step 1, wait an additional five
seconds before proceeding with Step
3. Once you start Step 3, you must
complete the procedure within 60
seconds.
3. For the seating position you are
switching off, buckle then unbuckle the
seatbelt three times at a moderate
speed, ending in the unbuckled state.
After Step 3, the seatbelt warning light
switches on.
4. When the seatbelt warning light is on,
buckle then unbuckle the seatbelt.
After Step 4, the seatbelt warning light
flashes for confirmation.

This switches the feature off for that
seating position if it is currently on.
This switches the feature on for that
seating position if it is currently off.
__________________
== były S-Max MK1 FL, Mondeo MK5, jest Ranger Wildtrak P703
domadm jest offline   Odpowiedź z Cytatem